What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 01.07.2025 10:59
An AC voltage/ current source, and an ac inductive load.
2024–10–10[John johnson John Johnson ]
These devices are installed between the “hot” and “neutral” and protective ground.
This is where this question deviates from being a 'generic' question, and becomes more specific.
In schematic diagrams this is the symbol for a fuse:
It also is a device that limits the change in current flow.
[image of Common-mode choke]
a photo is worth a thousand words.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
What are some common health concerns for senior citizens?
2024–10–16 [ OO OLAOYE OYEBODE ]
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Live Updates From Apple WWDC 2025 🔴 - Gizmodo
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This device then solves the entire problem.
Scientists create a two-dimensional carbon material eight times stronger than graphene - Earth.com
eight
(Dc diagram shown, AC is similar).
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
New tachyon study could unlock the secrets of time travel and reality - The Brighter Side of News
but this device (an Inductor) … impedes the rapid changes in the current.
[old diagram got deleted by accident]
What does a fuse do?
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
nine
What is lightning?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
2024–10–14 [Omar Gharbi Omar Gharbi ]
There are two important concepts here.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
One is “what exactly is in a ‘surge protector’ ? ”
the problem then depends on "how fast does the fuse operate?".
‘Black Swan Event’ Could Trigger 25% Drop in Alphabet Stock, Warns Barclays - TipRanks
First Sentence:
Now when you have a certain ac resistance, then a current flows in a loop.
This is 'the assistant's answer'
Trump leans on GOP senators as they gear up to make changes to his domestic policy bill - CNN
Upvotes:
A fuse is a non-resetable over current circuit protector.
But… the neutral is now “floating” because of the 1 ohm resistance.
Dental experts reveal 6 essential tips to prevent tooth loss in aging adults - AOL.com
At least they know the answer if they wanted it.
Here is a simplified AC power diagram.
It seems Mohan does not understand the difference between a comment and an Answer.
Brian Daly Named Director of Division of Investment Management - SEC.gov
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
but I think this circuit , shows a few more pieces.
He then describes the function of a fuse.
He then describes Rainy Season and Lightning.
A circuit breaker is similar, but is resettable.
so, what happens?
This is the picture of an electronic coil of wire wound around a core of magnetic material.
I post the exact comment here.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
At one ohm, the resistor has a maximum of 1 watt power.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
There are three different concepts here that are getting confused.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Because the load is inductive, the current lags the voltage.(by a bit).
One
The other is “what does a “fuse” do?”
what exactly is a ‘surge’ protector?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
But it can get overloaded, and no longer works.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Barnstars:
The bolt then partially travels down the line to your home.
This one hit behind the barn.
This is where the MOV conducts again, and dissipated the energy.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
So, the voltage could go up to 500 volts, and the fuse will not open up.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Edit 2024–10.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
The third is lightning and “how it gets conducted into a home.”
These are simplified answers to the original question, and does not change anything I wrote above.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
He then asserts :
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
For this case there are devices called Metal oxide varistors (MOV).
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.